#Poulan weed eater bad spark plug symptoms full#
If not, move the choke lever to the full position and pull the rope two more times. The engine should start after 2-6 more pulls. Set the choke lever at the half position and resume pulling the starter rope.This should happen between 1-6 pulls, but no more than 6 pulls Make sharp, brisk pulls on the starter rope until you hear the engine attempt to run.
If the unit has a primer bulb, depress it 4-5 times (the bulb should be at least 1/2 full).If the unit has an on/off switch, move it to the on position (usually indicated by the symbol "I", not "O").Hold or lock the throttle in the on position (the throttle must be held or kept locked until the engine is warmed up).Move the choke lever to the full position.
#Poulan weed eater bad spark plug symptoms manual#
Use the procedure outlined in your operator's manual if it differs from the following: If the unit is to be stored for longer than 30 days - drain the fuel tank, retighten the gas cap, and start the unit and let it run until it stops.Ī: Starting most two-cycle engines is quite simple. It is important to prevent gum deposits from forming in the fuel system. Our engines are calibrated to run on 87 octane regular unleaded gasoline.Ī: No, fuel should not be stored in the unit. Fuels with more than 10% alcohol can rob your engine of power and cause your engine to run erratic. These alcohol blended fuels attract moisture and form acids which can damage the fuel system. BUT do not store the unit with this mixture. Q: Can I use alcohol blended fuels in my unit?Ī: Alcohol blended fuel (called gasohol, or using ethanol or methanol) can be used with up to 10% alcohol. Remember to use fresh gasoline and to mix it with the recommended 2-cycle oil. You can use gasoline which is blended with a maximum 10% alcohol. Never use straight gas in a two-cycle engine as straight gas will ruin the engine within minutes.Ī: Our units run on 87 octane regular unleaded gasoline. Unlike engines that have separate gas and oil reservoirs, two-cycle engines run on a gas/oil mixture that keeps the engine lubricated at all times. Q: Why do I have to use a Fuel-Oil mixture?Ī: All Poulan Pro two-cycle products require oil to be added to the gas. To properly insure oil and gas mixture, we recommend thoroughly shaking your oil and gas mixture before refueling your unit. Over a period of time oil will separate from gasoline. of two cycle air cooled engine oil with one gallon of regular gas. You can obtain this ratio by mixing 3.2 oz.
0 kommentar(er)
